Commercial services
Commercial Refrigeration
Walk-ins and reach-ins, emergency repair, scheduled maintenance and custom installation, out of the same shop that runs your AC.
Most HVAC shops stop at the thermostat. This one doesn't.
A restaurant walk-in or a shop's reach-in case is a product-loss clock the moment the compressor short-cycles or a door gasket starts losing the seal a few degrees at a time. Prime Texas Air runs commercial refrigeration repair, maintenance and installation as a standing line of the business, not a side favor. Repair calls cover both walk-ins and reach-ins, and installation work is described on the shop's own service list as custom setups, meaning the unit gets sized to the space and the load rather than bolted in generic. Most HVAC outfits around The Woodlands are comfort-cooling only, so a business with a cooler usually ends up with two vendors and two invoices. Here it's one crew, one shop, one call at 8505 Technology Forest Pl.
What a maintenance visit actually checks
A refrigeration maintenance visit is where a coil iced over from a bad defrost cycle, a door gasket that no longer seals tight, or a compressor starting to short cycle gets caught before it turns into warm product on a Friday night. None of that shows up on a thermostat. It shows up in the case, and it's usually already happened once before anyone calls.
5.0 stars from 20 Google reviews, out of a shop at 8505 Technology Forest Pl Ste 501 in The Woodlands that runs commercial refrigeration and residential HVAC side by side.
What actually brings a refrigeration call in
The Gulf Coast humidity load doesn't do a walk-in any favors. A condensing unit working harder than it should in August heat, an evaporator coil icing up because the defrost cycle stopped timing right, a door hinge sagging just enough that the gasket stops sealing on one corner, these are the calls. None of them look urgent from the outside until the case temperature starts drifting and the product on the shelf is the thing that pays for it.
Repair calls are handled as emergency work on both walk-ins and reach-ins. Maintenance visits are scheduled, not reactive, and they're the reason most of these problems get caught as a gasket swap instead of a lost weekend of product. Installation is built around the space, described on the shop's own service list as custom setups rather than a stock box dropped in and wired up.
See the rest of what the shop covers on the services page, or send the details through the contact page if now isn't a good time to call.